Donaldson DPF Pulse Cleaner Thermal Regenerator

Donaldson DPF Diesel Particulate Filter Pulse Cleaner with DPF Thermal Regenerator, NewNever Used, Ready to work!

Donaldson DPF Pulse Cleaner

Features

• Uses high-volume, low-pressure pulse to dislodge unburned soot/ash from the DPF
• Captures soot/ash in disposable ash receptacle
• Self-contained cleaning system prevents contaminant from escaping into ambient air during operation
• Short process time - 20 minutes or less
• Unique universal DPF adapter accommodates Donaldson and other DPFs (11-15” diameter and 11.5-20” length)

Specifications

SIZE, WEIGHT AND CLEARANCE

28” Width x 43” Depth x 79” Height
Clearance requirement: 4” on left side;
12” on right side for crank handle and
12” on the back side for filter service.
Unit Weight: 700 lbs

ELECTRICAL AND COMPRESSED AIR REQUIREMENTS

Standard connection: 120V-15 amp
Clean, dry compressed air source: 90 PSI minimum shop air at 4 CFM

Finish(Interior & Exterior)

Hi-gloss, powdered coating finish

STANDARD REPLACEMENT PARTS
Ash Receptacle

Ash is a very fine particulate and requires care when handling. For convenience during service, use the cap included with the new ash receptacle to contain the contaminant during disposal and handling. The ash receptacle must be replaced when the life test pressure reading is above 2” H2 0 on the pressure gauge.

Donaldson DPF Thermal Regenerator

Features

• Burns soot/hydrocarbons off filter
• Heating cycle enhanced with low-volume, low-pressure pulse
• Enclosed cleaning system
• Collection hopper for ash
• Built-in safety features
• Accommodates competitive filters and Donaldson filters (DPF sizes from 11" to 15" diameter and up to 20" long)

Specifications

SIZE, WEIGHT AND CLEARANCE

28" Width x 43" Deep x 68.5" Height
Clearance requirement: 12” on all sides.
Unit Weight: 500 lbs.
Requires and exterior vent connection to roof our outside wall.

Electrical & Compressed Air Requirements
Power Supply: Single phase 30 am 208 or
240VAC with 15 amp 120VAC
Clean, dry compressed air source: 65-100 PSI
shop air at 4 CFM